How To Apply Pre Glued Press On DIY Lashes
Meet The Press On Method.
No Bond. No Seal. No waiting. Each Press On lash segment comes with adhesive already applied, making this our quickest and easiest DIY lash system.
Peel. Place. Press. Fuse.
The glue is already there.
Each Press On segment has a pre-glued adhesive strip attached to the base. Your job is simply to keep that adhesive clean, place the segment underneath your natural lashes and fuse everything together with your fingers.
Meet your pre-glued lash
Each lash segment already has a pre-glued adhesive strip attached to the base.
Before application, that adhesive is protected by a small cover strip. Carefully remove the protective cover so the adhesive underneath is exposed.
Once the protective strip is removed, try not to touch the pre-glued band with your fingers or applicator.
Hold them at the tip
When removing your lash segment from the tray, hold it right at the tip of the lash fibres and stay away from the pre-glued base.
Holding the segment at the tip keeps the adhesive clean and gives you much more movement and control while you're applying.
Tip of the lash = yes.
Pre-glued strip = hands off.
Clean lashes = better grip.
Give your natural lashes a proper wash before you start and let them dry completely. Makeup, oils and skincare residue can interfere with how well the pre-glued strip grips your natural lashes.
Apply underneath
Hold your Press On segment at the tip and place the pre-glued base underneath your natural lashes, slightly away from the waterline.
Press the segment into place.
Then use two clean fingers to gently sandwich your natural lashes and the Press On segment together.
Use a medium, controlled squeeze with your fingers. Enough pressure to fuse the lashes together, but not so much that you flatten or push the adhesive out.
Overlap as you go
When adding your next segment, slightly overlap it with the segment already in place.
This helps create a seamless lash line and keeps your finished set looking beautifully connected.
Place underneath, press into position and gently fuse again with your fingers.
Fuse With Your Fingers.
No tweezer clamping. Use two clean fingers and give each segment a controlled medium press so the pre-glued band connects properly with your natural lashes.
Too sticky or falling off?
Your pressure during application can tell you a lot.
Feeling sticky later?
You may have pressed too hard during application.
Next time, use slightly less pressure when you fuse the segment to your natural lashes.
Segments falling off?
You may not have pressed firmly enough.
Give each segment a controlled medium squeeze with your fingers,
and make sure you're slightly overlapping as you go.
Press On Aftercare
Keep Them Clean
Start with clean lashes and avoid oily products around the lash line.
Finger Fuse
Use your fingers rather than tweezers to press the segments securely in place.
Sleep Smart
A lash-friendly sleep mask can help protect your finished set from rubbing overnight.
Single Use
Press On segments are not reusable. Once removed, they should be discarded.
Press On = single use.
Our Press On lashes are designed as a pre-glued, single-use DIY system. Once you've worn and removed your set, those segments are done. If you want clusters you can clean and reuse, choose our Bond + Seal system instead.
The Press On Cheat Sheet
Keep Glue Clean
Avoid touching the pre-glued strip once the protective cover is removed.
Hold The Tip
Pick up and apply each segment from the very end of the lash fibres.
Overlap
Slightly overlap each segment for a seamless, secure lash line.
Medium Press
Fuse with two clean fingers. Secure, but never squashed.
Peel.
Place.
Press.
Go.
No Bond. No Seal. No waiting. Just pre-glued Press On lash segments ready to apply at home.
Shop Press On Lashes